View Single Post
Old Jan 26, 2013, 04:57 PM
flyeraroo is offline
Find More Posts by flyeraroo
"whirlydude"
flyeraroo's Avatar
United States
Joined Sep 2008
1,526 Posts
The ball links from the swashplate to the lower blades should be vertical. Yours are angled from what I can see. It would appear if something has slipped or broke on the lower part of the lower rotor hub. It could be the lower part of the rotor has dropped slightly, and then turned some. You may have to remove the lower rotor hub, and check it. It may be possible to loosen the 2 setscrews, (on the lower part of the rotor hub) then straighten the links by turning the lower part of the rotor. Make sure it's tight up against the upper part of the rotor hub, then snug up the setscrews to prevent it from slipping. If the links go at an angle again, it may be something is broke.
flyeraroo is offline Find More Posts by flyeraroo
Reply With Quote