View Single Post
Old Jan 26, 2013, 12:54 PM
-S- is offline
-S-
Find More Posts by -S-
-S-
Just one more..... Just one...
United States, TX, Henderson
Joined Jan 2010
1,471 Posts
Finished up the dual wing servo mounts, 1/16 of an inch thick brich ply, I used a very thin "diamond coated" cutter wheel from Harbor Freight to cut the slots.

Very good cutters for the price.

I CA'd the hard balsa in the wing, put the screws in took them back out and used thin CA to harden up the threads.

I decided to go with HS-225BB's in the wings as the standard HS-485's were really too big and really overkill for the purpose. The 225's specs are below.

Motor Type: 3 Pole
Bearing Type: Top Ball Bearing
Speed (4.8V/6.0V): 0.14 / 0.11 sec @ 60 deg.
Torque oz./in. (4.8V/6.0V): 54 / 67
Torque kg./cm. (4.8V/6.0V): 3.9 / 4.8
Size in Inches: 1.27 x 0.66 x 1.22
Size in Millimeters: 32.26 x 16.76 x 31.00
Weight ounces: 0.95
Weight grams: 26.93

More as it comes along
-S- is offline Find More Posts by -S-
Last edited by -S-; Feb 12, 2013 at 08:23 PM.
Reply With Quote