Thread: Discussion HoverflyGIMBAL settings thread
View Single Post
Old Jan 25, 2013, 11:02 PM
jbdww is offline
Find More Posts by jbdww
3D Heli and Planes
jbdww's Avatar
United States, TX, Round Rock
Joined Nov 2009
296 Posts
Quote:
Originally Posted by gww528 View Post
With the below fireware update, What is the output rate for servos before the v1.9 firmware update?

----------------------------------------------------------------------------------------------------------------

HoverflyGIMBAL firmware version 1.9

Ben Halsted
posted this on Jan 22 03:15 pm
There are two changes in this firmware.

1) You can now select the output rate for the servos (200hz, 100hz, or 50hz). Analog servos should use 50Hz. The majority of digital servos will use 200Hz, but a few on the market may use 100Hz.

2) There is a feature to limit the roll servo when the tilt angle exceeds a certain amount. This is useful for some of the more exotic continuous rotation gimbal designs in which the roll axis comes after the pitch axis in priority.
So where do you set the output rate? I do not see this option.
jbdww is offline Find More Posts by jbdww
Reply With Quote