View Single Post
Old Jan 25, 2013, 04:54 PM
flying-llama is offline
Find More Posts by flying-llama
Sopwith Camel's Cousin
Between my tx and crashed aircraft
Joined Mar 2006
3,831 Posts
"Knobs" to adjust Guardian mode and/or gain on-board an airplane

For those interested in having a "knob" on-board an airplane to adjust the Guardian mode and/or gain, either temporarily or permanently, perhaps due to a lack of channels on the Tx:
There is an "Esky servo tester" (EK2-0907 ?) that weighs about 1/2 ounce and has a knob to adjust signal to an attached servo (to test the servo).

One can put this or another similar "servo testor", hooking it up to the power for the servos and either the mode or gain line.
On the gain line, turning the knob can adjust the master gain control.
On the mode line, turning the knob can set the Guardian for 2D or off or 3D.
This can let one also reset level and/or trims.
This can also let one tell the Guardian to enter the mode to program it via the Tx sticks.
flying-llama is offline Find More Posts by flying-llama
Reply With Quote