Originally Posted by Tom Frank
To power the camera via the mini USB plug.
Actually I will connect it direct to the PCB (where the battery leads go as standard). I did this before and it worked fine apart from the camera shutting down when the flight pack voltage dropped under load. Had a micro JST plug/socket in the flyead so I could remove the camera from the quad.
Obviously the clock gets reset every time I change flight pack, but I have the timestamp off so it's no big deal.
I did consider RF noise as a potential issue ... both for the #11 and for the quad. I will have to try it and see. Not worried about FPV interference though ... no AV out on #11 (mine, anyway)!