Realized my mistakes, on the the next Tilt-Rotor build
I was just sitting here and thinking about the failures of my custom autopilot that I used for my Tri and Bi-copter tiltrotor. I was calculating my angles wrong. Perhaps I'll switch to quats. Anywho, with the realization that my autopilot wasn't having hardware issues, I feel motivated to actually get together my next aircraft together without having to redo my autopilot board. I already have most of the parts sitting in my garage.
And yes. I use pinterest and it is awesome for hobby stuff. I plan on making this a complete tiltrotor with full transition capabilities.
Also, I recently verified that the HobbyKing 6Channel RX V2 outputs a combination of all the other channels on the 7th pin block (not quite PPM), as described here
I plan on using this fact to reduce my wiring.