View Single Post
Old Jan 24, 2013, 01:20 PM
Jimob23 is offline
Find More Posts by Jimob23
Registered User
United Kingdom, England, Ware
Joined Aug 2012
180 Posts
Quote:
Originally Posted by Gaz-b View Post
when I rebuilt my flywheel I used some rubber sealed ceramic's and removed the inner seal to further reduce drag although they felt very good this also allowed the excess lube to be thrown out. With the flywheel lying flat fitted them with thread lock to take up any slop in the flywheel machining.
Following on from Johnnymac's comment regarding bearings this is interesting possible .
In my investigations I was advised against partial ceramic as the possible impact could fracture the balls
There is still the problem with the steel outer and inner with water etc
Fully ceramic would perhaps get over the water problem but the ceramic outer is not designed to be press in tight fit as for steel outer and can fracture .
As I said will be interesting to hear as to how they stand up and for interest what was the cost of the 3 x ceramic as I was led to believe they talk in telephone numbers regarding price .

cheers Jim
Jimob23 is offline Find More Posts by Jimob23
Reply With Quote