Thread: Build Log Plank 1mp
View Single Post
Old Jan 24, 2013, 03:19 AM
Jon Snow is offline
Find More Posts by Jon Snow
You know nothing....
Jon Snow's Avatar
Joined Sep 2011
3,626 Posts
Servo fitted.I cut straight through the wing to set the thing as deep as possible.
Waxed plastic sheet betwixt bed and wing,piece of thin glass big enough to come up the sides,another piece in the bottom and a 1/32 piece of ply on top
A mix of epoxy,micro balloons and a touch of graphite for visibility.
The servo and the balsa block I wrapped in two layers of kitchen film.
So,all masked round,a generous amount of epoxy between the layers and on top.
Pressed the servo in and removed excess,every thing weighted down.The open ended (cocktail stick) box stood on the servo with 4 blocks on top.
The result- worked ok,if a little messy.The servo is a nice fit,I need to fix the connecter on the wires and see where I can sit the extension.
Not bad for a first attempt at this kind of install.
Jon Snow is offline Find More Posts by Jon Snow
Reply With Quote