Thread: Question Enya .45
View Single Post
Old Jan 23, 2013, 08:50 PM
retromark1 is offline
Find More Posts by retromark1
Registered User
Joined Jun 2012
13 Posts
Bert I need some help.I had to replace the gas nipple on the needle valve.In doing so I took it off from the carb. As I attempted to replace it I realized that there is a nut on the threads of the needle valve which allows you to attach it to the carb at different depths. How far should I place the needle valve into the carb ? Thanks Mark
retromark1 is offline Find More Posts by retromark1
Reply With Quote