Thread: Discussion Walkera V400D02
View Single Post
Old Jan 23, 2013, 04:34 PM
chrisnc is offline
Find More Posts by chrisnc
Registered User
chrisnc's Avatar
United States, NC, Whitsett
Joined Jun 2012
39 Posts
jfranklyn,
You might also check to be sure that they are all moving the same direction individually. I installed some Fusonic servos recently, had some weird stuff going on with the movement once I programmed everything, and then decided to test them with my servo tester. Turned out that two of them were moving in the opposite direction from the third. I opened them up and they were all wired differently.
Two choices, fix them to move like stock by re-wiring, or fix them to move all in the same direction, but opposite of stock, then reverse in the tx, and flip around the receiver. Since I was fixing them anyway, I re-wired them to move the same as stock and everything worked great.

Oh, and don't reverse RUDD.

Hope that helps.
chrisnc is offline Find More Posts by chrisnc
Reply With Quote