Thread: Discussion Improve Tx antenna
View Single Post
Old Jan 22, 2013, 12:01 PM
jakestew is offline
Find More Posts by jakestew
Registered User
United States, ID
Joined Sep 2011
1,223 Posts
You can cut that PCB antenna right where it leaves the ground and solder on something else. Any antenna will probably do a little better than the PCB antenna. There's various reasons the best length may not be the theoretical length, you'll have to do some experimenting. There's lots on the net about different antennas you can try. I'd probably start with a piece of solid copper wire.
jakestew is offline Find More Posts by jakestew
Reply With Quote