View Single Post
Old Jan 21, 2013, 07:27 PM
RickEis is offline
Find More Posts by RickEis
Registered User
United States, AZ, Prescott Valley
Joined Feb 2012
179 Posts
Quote:
Originally Posted by Tang0au View Post
i got all the items in to build this with an arduino nano & sparkfun max7456, bmp085 and the gyro board (all specified through this thread)

i was running this on the test bench with version 8, and all seemed stable ... upgraded to version 10 and after a short random period, maybe 2 mins ish, the bmp altitude goes mental scaling up & down to the max limits, the altitude numbers next to the bar shows random characters & letters then the arduino hangs and needs to be reset.

any ideas where to start ? what other info is needed to debug ?
Hi TangOau,

I think I know where to start .... well actually where to go back
Try disconnecting the gyro and all should be good. At least my Nano version works fine without the gyro.
Dennis has not finished the code for the gyro yet. I think if you back a few posts you will see that discussion.

Hopefully that helps,

Rick
RickEis is offline Find More Posts by RickEis
Reply With Quote