View Single Post
Old Jan 21, 2013, 06:15 PM
Tang0au is offline
Find More Posts by Tang0au
Registered User
Joined Dec 2012
35 Posts
i got all the items in to build this with an arduino nano & sparkfun max7456, bmp085 and the gyro board (all specified through this thread)

i was running this on the test bench with version 8, and all seemed stable ... upgraded to version 10 and after a short random period, maybe 2 mins ish, the bmp altitude goes mental scaling up & down to the max limits, the altitude numbers next to the bar shows random characters & letters then the arduino hangs and needs to be reset.

any ideas where to start ? what other info is needed to debug ?
Tang0au is offline Find More Posts by Tang0au
Reply With Quote