Thread: Discussion New Eclipse 2.4 PRO?
View Single Post
Old Jan 20, 2013, 09:22 PM
alwaysconfused is offline
Find More Posts by alwaysconfused
Registered User
Joined Dec 2012
287 Posts
Quote:
Originally Posted by A.T. View Post
1. Set up model up under "Heli" rather than "Acro", this permits use of the three position Gyro switch as attached.
2. Under "Acro" a slider can be used, with some models,in lieu of a switch.
Min = Pos 1, Centre = Pos 2, End = Pos 3. (EPA may need to be extended to max)

Alan T.
Alan's Hobby, Model & RC FAQ Web Links
I have the eclipse 7 pro as well and after reading through this thread... In order to program my hexacoptor I will need to set it up in HELI mode in order to engage the GPS-ATTI, ATTI and MANUAL modes via the 3 pot switch? If not required then how can I set it up. I am finding it frustrating and impossible because it keeps asking em to have a master and a slave...meaning I have to hit 2 separate switches that wont even "EPA" into position. Need some serious help here.

Thanks in advance.
NAZA
NAZA GPS
OPTIMA 7 Rx
HITEC Eclipse 7 pro Tx
alwaysconfused is offline Find More Posts by alwaysconfused
Reply With Quote