Originally Posted by DaFats
Has anyone been successful at making 1.25inch fuse's? I ask only because I am thinking about P38 style FPV plane 80 inch wing span (30/20/30)... able to run twins on the outer booms for a heavier payload or a faster more local mission, or run a large pusher with folding prop for longer range FPV. The center "Cockpit) will hang under the wing and obviously handle the payload Batteries, Pan and tilt camera, go pro. Do you think the 20 inch spread between the Booms is enough space to place Vtx on one side and Rx on the other and avoid interference? Would the 1.25 inch booms be large enough to accept Dlink Reciever and ant. on one side and Vtx/CP ant. on the other?
I have done a couple of twin boom planes. An SO-11 type and a personal design. Check the 2nd plane in the video. The booms are triangular and taper to 1.25 at the tail.