View Single Post
Old Jan 20, 2013, 03:00 PM
kahloq is offline
Find More Posts by kahloq
Registered User
kahloq's Avatar
Fort Collins, Colorado, USA
Joined Dec 2005
7,821 Posts
I added extra glue around the joints in the retract mount areas, but nothing drastic.

In the 1st one.....the throttle servo is on the underside of the tray.

2nd one shows routing of the flex muffler. I dont recommend this as it is too easy for the motor to flood and happens quickly. I have to use surgical clamp(hemostats) to pinch close the carb fuel line while fueling and can only remove them until Im absolutely ready to start the motor. Also have to fill an outside fuel tankl of same displacement as whats in the plane then transfer it to plane otherwise cylinder will still flood thru the muffler exhaust port. This can be avoided if a fuel regulator is installed.

3rd pics shows I made the gun hood open so I could hide all the switches.
kahloq is offline Find More Posts by kahloq
Reply With Quote