View Single Post
Old Jan 20, 2013, 05:39 AM
Rappy_Chappy is offline
Find More Posts by Rappy_Chappy
Registered User
Rappy_Chappy's Avatar
Livingston, Scotland UK
Joined Dec 2003
320 Posts
I did my other three Plush 40s controllers today without a single problem. These boards are v6.21 and are the same layout as the HobbyWing/ FlyFun board. The 6.0 board which I have is the normal Plush 40 layout (i.e. the solder pads for flashing at the edge of the board). Regardless, they all accepted the Turnigy Plush 40a hex file 9.3 Multi using BLHeliTool v1.01 beta.

As I am planning to use all four of these in a quad, will there be a problem with running one 6.0 board along with three 6.21 boards?

I am so grateful to OlliW for his fantastic work - guys like this are an essential asset to our hobby and deserve recognition.
Rappy_Chappy is offline Find More Posts by Rappy_Chappy
Reply With Quote