View Single Post
Old Jan 20, 2013, 12:08 AM
Laidback_racer is offline
Find More Posts by Laidback_racer
Build the Weapon....
Australia, VIC, Berwick
Joined Jan 2013
913 Posts
Quote:
Originally Posted by camano27 View Post
Well if that's the case, it could very well be the novice soldering job I did on those TINY oem pin lugs. Very delicate work. Maybe id be better off using the oem wire and soldering to the motor, which isn't as delicate?
Perhaps try soldering the new heavy wires from the motor direct to the PCB as Steve suggests?
Laidback_racer is offline Find More Posts by Laidback_racer
Reply With Quote