Originally Posted by craigiri
This is usually obvious - but I cannot stress enough that you have to put it on a perfect level surface for about 12 seconds after you insert the battery.
Since I have messed around with my legs - I set mine inside a small cup or can which makes the arms rest on it - that assures level.
I did have to replace one of my motors, so that is a possibility. They are only a few dollars apiece if it comes to that. But try everything else first. You need to solder to replace a motor!
Thank you guys! I hope it is only motor and not "motherboard". I tried to start it on level surface but it didn't help.
What causes the motor damage? Yes it crashed a lot. Is that the cause?