Thread: Question Enya .45
View Single Post
Old Jan 17, 2013, 08:45 PM
coriolan is online now
Find More Posts by coriolan
"Unnecessary Necessity"
coriolan's Avatar
Canada
Joined Sep 2006
6,600 Posts
That sticky will answer most of your questions:
http://www.rcgroups.com/forums/showthread.php?t=205602
And if it's an airplane engine that forum might be more helpful:
http://www.rcgroups.com/engines-140/
The only thing that would really prevent a glow engine from running at all would be a dead glow plug(nothing happen). If the engine run on the prime but die after a few seconds it would indicate either no fuel getting to the carb or an HS needle ways too lean. Its much easier to assess an unknown engine at full throttle to set the HS needle before fiddling with the carb. Here is a scan of the manual for most Enya engines:
http://www.rojobcn.com/catalogos/eny...enya200601.pdf
coriolan is online now Find More Posts by coriolan
Reply With Quote