View Single Post
Old Jan 17, 2013, 03:49 PM
SCALECRAFT is offline
Find More Posts by SCALECRAFT
Registered User
Joined Apr 2004
815 Posts
Typical mold work.

I reused the parting boards by putting the stands on the other side to create a opposing side to support the glass molded side of the fuse.

Hard to see in the pics is the clear packing tape I put on the outer edge of the glass mold. This will keep the 2nd 1/2 mold glass bonding to the untrimmed 1st 1/2 since I can't really put any mold release on it.. The tape will also show where the two molds will meet and make it easy to split later for it's 1st time.

Almost there.

Steve
SCALECRAFT is offline Find More Posts by SCALECRAFT
Reply With Quote