Thread: Discussion Emax 2210/30 excavation
View Single Post
Old Jan 17, 2013, 08:04 AM
zeroback is offline
Find More Posts by zeroback
Suspended Account
United States, FL, Pompano Beach
Joined Oct 2011
1,425 Posts
The Emax's of that era apparently were hand wound, Jack's tear down of one was a gooped up mess. This Emax was machine wound, not much wire BUT the turn count was a perfect 14 turns on each arm. This one is sold as a 1300Kv and when tested was within 20 rpm. It did perform to the specs available at Heads Up RC. Although at that power level it was heating up and would be a considered a burst verses a constant power level. The unwinding revealed a phase that one of the three conductors was broken., with that wire in tacked the motor would have done better.
zeroback is offline Find More Posts by zeroback
Last edited by zeroback; Jan 17, 2013 at 08:09 AM.
Reply With Quote  (Disabled)