Thread: Question What size pipe?
View Single Post
Old Jan 17, 2013, 12:39 AM
SilentHunter is offline
Find More Posts by SilentHunter
Registered User
SilentHunter's Avatar
United States, Death Valley
Joined Aug 2003
3,113 Posts
Question
What size pipe?

Where to get a single wall, simple pipe sized for a Wren44 or P-60 size turbine? I need a 17" section minimum. I assume they would be close to the same diameter for these two engines? Whats the recommended diameters anyway BTW? I'm assuming they are about the same... Is it the same diam as the turbine wheel?

I already have an outer wall, I need an inner to complete my pipe.

Also where are fiberglass bypass sections for these sized engine?

Thanks for your help!
SilentHunter is offline Find More Posts by SilentHunter
Reply With Quote