View Single Post
Old Jan 16, 2013, 07:47 PM
theothercliff is offline
Find More Posts by theothercliff
Much happier at LibrePilot!
Temple, GA, USA
Joined Jun 2009
3,156 Posts
Quote:
Originally Posted by rshep View Post
NO TEXT ON LCD: HK PDB, F-30 ESC#1 to M1 (just signal wires to other M2-M4) ... bind the RX. Turn on TX, then power up KK2.0, start looking at menus etc ... hearing infrequent tiny beeps? ... went to set low voltage value and ... screen has only a backlight now!
Tried KaptK jumper instead of 220R ... nothing. Tried to reflash KK2 ... no go. Tried to reorder another KK2 ... backordered. ... not having a good last 2 days ... ???
You don't have metal screws or standoffs for mounting the KK2 do you? Did you ever? Carbon fiber is a no-no also.

Does the LCD light up with text if you disconnect everything and power it from the programmer through the 6 pin programming connector?
theothercliff is offline Find More Posts by theothercliff
Reply With Quote