View Single Post
Old Jan 16, 2013, 01:09 PM
major.monogram is offline
Find More Posts by major.monogram
Trader Rating: 56
Pastor of Muppets \m/
major.monogram's Avatar
United States, TX, Corinth
Joined Mar 2010
1,244 Posts
Trader Rating: 56
Hey guys. I hope this isn't too off topic but i was flying yesterday and my low voltage alarm didn't go off that i could tell. I just started losing power and my leds dimmed. I have it set to 105 in misc settings. Is that the correct setting? Do I need to do anything else? Is the alarm loud or is it just a little beep? Maybe I'm just not hearing it. Thanks for any info! And thanks to creepy1 for telling me to look in misc settings.

Oh and I'm using a 2200mah 3s 45-90c packs. Thanks again,

Casey

I should add that I flew across the way at the park for 5 minutes then came back to my house and hovered in the garage for a minute or two. It was in the garage that it lost power. Still no crashes as of today but i'm staying mostly tail in. I have bent the crap out of the cnc gear several times. I have a spare set but i haven't bothered putting them on yet. I just keep rebending the bent. I'm not even removing them to get them straight just kind of lazily unbending them.
major.monogram is offline Find More Posts by major.monogram
Last edited by major.monogram; Jan 16, 2013 at 01:17 PM.