Thread: New Product Change Sun 10 blade 70mm
View Single Post
Old Jan 15, 2013, 02:42 AM
GryphonRCU is offline
Find More Posts by GryphonRCU
Registered User
GryphonRCU's Avatar
United States, CA, SF
Joined Mar 2008
4,033 Posts
I limit my no load motor runs to about 5 seconds......just to get no load KV from ICE ESC or Eagle Tree data logger w/brushless RPM sensor.

The motors do heat up more than I expect without a load on them.

Pole count also has some effects on how much they heat up.


I don't see any good reasons to run longer duration no loads....if it was not for occasional initial hickups by various loggers, I would shorten it down from 5 sec.



Gryphon
GryphonRCU is offline Find More Posts by GryphonRCU
Reply With Quote