Thread: Discussion HoverflyGIMBAL settings thread
View Single Post
Old Jan 14, 2013, 09:22 PM
matthewlavin is offline
Find More Posts by matthewlavin
Registered User
United States, CA, Santa Cruz
Joined Dec 2011
354 Posts
Quote:
Originally Posted by Michael64 View Post
You should ony have one source of power coming in to the gimbal cotroller not two. If you are using a single receiver you only need to run a single wire for signal to the receiver using a common ground. If you use a seperate battery you will need to run ground as well just not hot lead.

Michael64
Yes I'm only using one receiver.
So pull the red wire connecting the receiver to the HFG?
matthewlavin is offline Find More Posts by matthewlavin
Reply With Quote