View Single Post
Old Jan 12, 2013, 09:05 PM
glewis is offline
Find More Posts by glewis
Or current resident
glewis's Avatar
USA, FL, Tampa
Joined Jul 2002
5,291 Posts
It's heat shrink tubing. A 90 degree bend won't stay in. A 'Z' bend works best, but once the pushrods are on they are hard to remove without a lot of trouble. The keeper is a separate piece of 0.015 wire.
The keeper wire isn't glued into the heat shrink to give it the flexibility needed to 'lock and unlock' them.

Glenn
glewis is offline Find More Posts by glewis
Reply With Quote