Thread: Build Log Wompoo Build Log
View Single Post
Old Jan 11, 2013, 08:30 PM
Jim.Thompson is offline
Find More Posts by Jim.Thompson
Entropy is happening!
Jim.Thompson's Avatar
Australia, NSW, Bellingen
Joined Aug 2008
8,047 Posts
Quote:
Originally Posted by wyowindworks View Post
Do your first layer of surface coat and let it go tacky. Brush the corner with resin (the same that you made the surface coat with) and add 3 strips of wet-out 12K carbon tow into the corner. Stipple each strip right into the corner the immediately add your second layer of surface coat. After this has gotten tacky you can pipe in some sploog into the corner and add strips of light glass that spans the corner to make a fillet.
Adam,

Actually, I did not explain well enough obviously. I'm having no difficulty whatsoever with internal corner for part manufacture etc.

It's the external corners, specifically the wing roots of the mould manufacture of this project that I am having (and previous projects like this one). External layup around the plug in other words. Difficulty in getting the fabric(s) to conform.

Thanks,

Jim.
Jim.Thompson is offline Find More Posts by Jim.Thompson
Reply With Quote