Thread: Discussion Blade MCP X - owner's thread
View Single Post
Old Jan 10, 2013, 12:58 PM
BrundleFlyBy is offline
Find More Posts by BrundleFlyBy
Never stop being a kid.
BrundleFlyBy's Avatar
United States, CO, Manitou Springs
Joined Jan 2012
543 Posts
Quote:
Originally Posted by St.Eve View Post
I tried wrapping the battery wire around the tail boom like you said but the wire isn't long enough, and even if it was, part of the wire rubs up against the small spinning gear. Any other suggestions?
I'm a new owner, also, and had the same concern. I've found that the wire is just long enough to allow working the battery out of the skid at an angle without straining it. With the battery hanging free, it's easier to disconnect without yanking on the wire.
BrundleFlyBy is offline Find More Posts by BrundleFlyBy
Reply With Quote