Thread: Discussion Open Flight Stabilizer
View Single Post
Old Jan 09, 2013, 03:43 PM
JohnRB is online now
Find More Posts by JohnRB
Registered User
United States, NC, Raleigh
Joined Oct 2011
1,135 Posts
Quote:
Originally Posted by noobee View Post
can you try
- causing the rx to go into failsafe mode
- setting the aux gain to zero

and see if any of the two reduces jitter? i would like to trace the source of the noise.
With the TX off, Receiver in Fail safe and ran for 5 minutes. Total jitter deviation over that period of time was 44us on Aileron Output.

How do I set aux gain to zero in fail safe mode?

I am doing the test again with the TX on and aux gain set to minimum (1ms pulse width) and the total jitter is still 32us.

John
JohnRB is online now Find More Posts by JohnRB
Last edited by JohnRB; Jan 09, 2013 at 04:01 PM. Reason: Correct Typo
Reply With Quote