Thread: Build Log Wompoo Build Log
View Single Post
Old Jan 08, 2013, 09:18 PM
wyowindworks is offline
Find More Posts by wyowindworks
Just fly it!
wyowindworks's Avatar
Cody, WY
Joined Nov 2007
6,919 Posts
Quote:
Originally Posted by Jim.Thompson View Post
Which brings to mind Adam, in the case of a square or rectangular joiner, would you use some of the joiner box (or tube if you like), to do the same job?
Except of course that you would not drill out the hole, but scribe it for later cutting out after pulling the part out of the mould I am guessing?

Jim.
You could do that....or have the guide hold a piece of joiner (release applied) that the fuse layup gets done around leaving a perfect hole.
wyowindworks is offline Find More Posts by wyowindworks
Reply With Quote