Thread: Mini-Review Walkera V200D01 - Mini Review
View Single Post
Old Jan 08, 2013, 07:14 PM
arrowshooter is offline
Find More Posts by arrowshooter
Registered User
United States, CA, Modesto
Joined Aug 2012
828 Posts
Quote:
Originally Posted by tengarang View Post
Dont worry about the questions, i rather you ask your way through every detail rather than unnecessary foul ups...I dont mind it...at all.

Leave the black(ground) and signal(white or some bright color) where it is.

you can remove the red connection out of the connector housing completely and insulate it with electrical tape...OR you can just cut the red wire out of the picture completely...its is the power supply, or the output of the internal BEC...since you are using an external BEC you want the internal connection removed fro the entire circuit.

refer to section 3.2 where it shows "center pin has to be disconnected"

http://www.hobbyking.com/hobbyking/s...X416823X44.pdf

keep em comming
Cool I got that, but then do I just plug the red/blk wires from seperate BEC to another open plug on the receiver? Only reason I ask is they say "not used".

Edit: Tried it and works! Thanks again for your time.
arrowshooter is offline Find More Posts by arrowshooter
Last edited by arrowshooter; Jan 08, 2013 at 07:23 PM.
Reply With Quote