Thread: Mini-Review Walkera V200D01 - Mini Review
View Single Post
Old Jan 08, 2013, 07:12 PM
tengarang is online now
Find More Posts by tengarang
Fly Straight Fly High
tengarang's Avatar
San Jose, California
Joined Aug 2010
4,185 Posts
Quote:
Originally Posted by arrowshooter View Post
Roger that on the red wire removal. Would I then put the external red wire in its place and do the same with the black wire? Sorry for all the questions, but I do want to avoid that meltdown.

Dont worry about the questions, i rather you ask your way through every detail rather than unnecessary foul ups...I dont mind it...at all.

Leave the black(ground) and signal(white or some bright color) where it is.

you can remove the red connection out of the connector housing completely and insulate it with electrical tape...OR you can just cut the red wire out of the picture completely...its is the power supply, or the output of the internal BEC...since you are using an external BEC you want the internal connection removed fro the entire circuit.

refer to section 3.2 where it shows "center pin has to be disconnected"

http://www.hobbyking.com/hobbyking/s...X416823X44.pdf

keep em comming
tengarang is online now Find More Posts by tengarang
Reply With Quote