Thread: Build Log Wompoo Build Log
View Single Post
Old Jan 08, 2013, 03:13 PM
Jim.Thompson is offline
Find More Posts by Jim.Thompson
Entropy is happening!
Jim.Thompson's Avatar
Australia, NSW, Bellingen
Joined Aug 2008
8,054 Posts
Square joiner question.

Quote:
Originally Posted by wyowindworks View Post
Oh, sorry, Jim. I see that you are parting the fuse the other way....which is just fine. You would just layup the mold halves around the drill guides.
Which brings to mind Adam, in the case of a square or rectangular joiner, would you use some of the joiner box (or tube if you like), to do the same job?
Except of course that you would not drill out the hole, but scribe it for later cutting out after pulling the part out of the mould I am guessing?

Jim.
Jim.Thompson is offline Find More Posts by Jim.Thompson
Last edited by Jim.Thompson; Jan 08, 2013 at 03:15 PM. Reason: Additional information.
Reply With Quote