View Single Post
Old Jan 08, 2013, 04:22 AM
airmamaf is offline
Find More Posts by airmamaf
Registered User
France, IdF, Neuilly-sur-Seine
Joined Jan 2012
92 Posts
Clear EEPROM

@SimonK and Lazy Zero
In github :
Quote:
There is currently no way to reset (remove) the calibration other than by clearing the EEPROM (or reflashing without EESAVE set).
In tgy.asm :
Quote:
If the boot loader is enabled, the last nibble of the hfuse should be set to 'a' or '2' to also enable EESAVE - save EEPROM on chip erase
When using KKMulticopterFlashTool, the last nibble of the hfuse is set to 'a' when bootloader is enable. Is there a way to clear EEPROM, to use default values of the firmware, when flashing with PWM (USB Linker) ?
Is it possible to upload a code to clear the EEPROM and then upload ESC firmware ?

Thanks,
airmamaf is offline Find More Posts by airmamaf
Reply With Quote