View Single Post
Old Jan 07, 2013, 02:53 PM
billpa is offline
Find More Posts by billpa
billpa's Avatar
Joined Nov 2003
4,949 Posts
Hi Alan,

I think you are saying that the data recorder + OSD is working (except the telemetry transmitter) but that the altimeter and powerpanel are still not working?

Assuming this, I'm confused about why both those units would just stop. is there any chance they were exposed to high voltage? I'm also a little worried that whatever caused the failure of the powerpanel and altimeter has now happened to the transmitter, as they all are on the same bus.

One more thing to try. If you connect the altimeter directly to the eLogger, and then connect the OSD Pro to the altimeter, does the altimeter flash, and does the OSD Pro show up under "Firmware Control."?
billpa is offline Find More Posts by billpa
Site Sponsor
Reply With Quote