Thread: New Product Pike Perfection
View Single Post
Old Jan 07, 2013, 01:27 PM
stefanoc2 is offline
Find More Posts by stefanoc2
Registered User
stefanoc2's Avatar
United States, TX, Houston
Joined Aug 2006
510 Posts
Tom,
the pin is all in the brass tube with no gap on top.
When the elevator is not in place the brass tube extends past the top of the levator saddle by a good 1/4" or more (will check again tonight). I think that with the elevator in place that 1/4"+ plus the down travel bends the push rod down and causes friction/binding where it exist the pushrod guide. This is just a guess.
Stefano
stefanoc2 is offline Find More Posts by stefanoc2
Reply With Quote