Thread: Discussion Walkera QR Ladybird
View Single Post
Old Jan 06, 2013, 07:45 AM
BD Murdock is offline
Find More Posts by BD Murdock
Quad guys are 4x the fun :)
BD Murdock's Avatar
United States, CO, Longmont
Joined Mar 2012
920 Posts
Quote:
Originally Posted by TurboRacer View Post
I did not try direct solder.. I tried going in to that spare plug.. Didn't even think to try soldering to battery leads. I shall give it a go, thanks for idea!
I set mine up so I could plug / unplug them. I bought a set of 6" E-Flite extension cables and just used the male plug and female socket, cut off and resoldered. That's where I attached my female plug, directly to the solder points that the battery cable is attached to. Male plug went on the end of my LED set-up. Take a few minutes though and plan the length and routing before you just heat up the iron and melt tin. I ended up re-doing mine once.
BD Murdock is offline Find More Posts by BD Murdock
Reply With Quote