Thread: Discussion Change Sun 12 blade 120mm
View Single Post
Old Jan 05, 2013, 07:55 PM
matchpoint is offline
Find More Posts by matchpoint
Registered User
Joined Oct 2012
129 Posts
I turned down the cooling fins on a lathe.
I bored out the motor housing slightly
I reinforced the motor mount with a carbon fiber sleeve.
I PU'd the blades.
I bought the 8mm turnigy shafts off hobbyking that are 103mm long, had a new snapring groove cut.
Press fit in new shaft. Shimmed accordingly.
Reinforced top of motor mount with more carbon.

I have three of these. Here is #1 before dynamic balance.

fan#2.wmv (0 min 25 sec)
matchpoint is offline Find More Posts by matchpoint
Reply With Quote