Updating OSD Pro firmware
View Single Post
Jan 04, 2013
, 03:36 PM
Joined Nov 2003
Hi Moby, and glad to hear you are getting back into the hobby!
Regarding the update issues, we've had one other report of an update issue when using the Flight Data Recorder Pro with the OSD Pro, and our beta builds. We are investigating this issue. What I would recommend is that you use your eLogger instead, until we get to the bottom of this.
The most effective way to do a full reset of the system is to folllow these steps:
1) Under the "Advanced" menu of our software, choose "Delete all Eagle Tree Settings"
2) Restart the software, and update the OSD Pro firmware.
3) access the OSD Pro setup page, and click "Factory Reset"
At this point, any issues caused by upgrade/downgrade should be remedied.
Regarding the issue with your altimeter and powerpanel, can you let me know the symptoms? Is the LED not blinking on the altimeter? And, does this occur when connected to USB as well as when using a battery? Note that when powered by USB alone, the PowerPanel is often too faint to read (it requires a battery connected to the eLogger's battery input to be fully visible).