Thread: Discussion UK FPV Thread
View Single Post
Old Jan 02, 2013, 04:28 PM
Upup is offline
Find More Posts by Upup
Registered User
Upup's Avatar
Ilford,Essex, UK
Joined May 2006
2,068 Posts
Quote:
Originally Posted by sidneylopsides View Post
That looks really good! I assume the frames are from b&q, what about the rest?
arms are wicks electrical conduit

6" centre plates from 4mm ply ( old cupboard back) with black emulsion paint

battery tray from half round black pvc gutter heated and flattened

round nylon spacers from old cutting board

6mm nylon machine screws from ebay

motor mounts half inch ply gorilla glued together, the hole in the centre was filled with a dowel and gorrila glue

lower motor mount washers cut from old ali double glazing

LG from a old fibre glass golf umbrella and the ends of a old pc hard drive

Also a short video testing the battery alarm on the KK2 board

IMG 0496[1] (1 min 5 sec)
Upup is offline Find More Posts by Upup
Last edited by Upup; Jan 02, 2013 at 04:36 PM.
Reply With Quote