View Single Post
Old Jan 02, 2013, 12:22 PM
Flysfloats is offline
Find More Posts by Flysfloats
Registered User
Flysfloats's Avatar
United States, WA, Oak Harbor
Joined Dec 2012
22 Posts
Ok, I give up. I have struggled with this build from the start and now I am just going to post a picture and ask for help.

My lastest dilemma is typical of my problems. I am working on the body and after reading the manual, looking at all pictures I can find, I still have questions.
Reference the attached picture & Pg 6 Step #5- -
#3 is the top/rear of the body. Just below and to the right of the #3 sticker is the 3/16" "screw hole doubler" (interesting choice of words). My guess is that either #1 or #2 or both are glued to the top of #3?? I doubt this is a critical choice but I would welcome an explanation, please.

#4 I have handled, I think, Ref Step #7

#5 I have no idea where this piece fits? It has a "B" on it indicating bottom someplace, anybody??

I posted these questions to see how they came out and was a test case for my picture posting ability. Thanks in advance. FF
Flysfloats is offline Find More Posts by Flysfloats
Reply With Quote