Make sure you are using the correct switching option,
(example) 3POS (RTH)
Then make sure that you are using the correct channel for the correct aux switch. and make sure that your transmitter is set accordingly.
Sorry to have to inform you of this but it is 99% likely that it is something that you have done, or a broken wire (connection).
Originally Posted by vosiacki
When the OSD powers up on the openeing screen I get the error msg NO MENU IMPUT (S) DETECTED.
It is relative to the Aux 1 and 2 inputs ...
I have replaced the leads from the RX to the OSD but the problem still remains.
Its worth noting that i am getting aileron and Elevator Control so the Receiver is working...
All commands aileron and elevator are functioning normally and also checked the keys in TX which move servos connected to them.
I installed the versions 10.04 and 10:43 beta, the corresponding firmware installed and the error still remains. Also swapped the receiver, all the wiring, did another memory in the transmitter and still nothing. What annoys me most is that sometimes the menu works, but then no more. The aeromodelo not suffered any fall. In the first flight was activated RTH because many glitches were detected. I disabled the option to detect these glithes via windows software.
All other functions are perfect (guardian, gps, menus that I set via software).
Before the first flight, the menu via aux channel 1 and 2 functioned normally. It was very easy configuration. But after these glitches being detected, could not configure by the transmitter OSD menus. I tried other options just a switch 3-position, also without success.
I am using a 3s 4000mah lipo celll to Elogger V4, OSD PRO, Cam and Imerssion 600mW video TX.
Does anyone have an idea what might be happening? Thank you!
600mW Immersion Video TX 5.8ghz
Orange Fasst 2.4ghz receiver
Futaba T8FG TX
Fatshark Aviator Video Receiver
Planar skill and Cloverleaf antennas