View Single Post
Old Jan 01, 2013, 10:49 AM
Isoprop is offline
Find More Posts by Isoprop
Registered User
Joined Nov 2010
2,864 Posts
Quote:
Originally Posted by rc9 View Post


. The picture above is from a V2 #11 with the 2 LEDs situated below the lens cut-out.

Iīve been asking for advice on the #18 tread but now when I came across this
pic........ maybye.... Isoprop you donīt happen to have a pic of the flipp side?

Does the #11 cam also have 2 ledīs (red charg/yellow on)?

My Problem will remain seens I canīt load any firmware anyhowe, but at least Iīll know why if I can confirm itīs not #18 but an #11 v2 cam Iīve got
The coil at the top left was broken by the previous owner but should look like the one next to the USB socket at the bottom right. This is how the board looked before I started stripping it....

It was originally sold as a #11, but I believe is identical to the #18. When (if) I manage to repair it, I'll know for sure. Among other things, the DRAM Hynix chip on the first picture is shorted. Since they are identical, both boards have 2 LEDs.

I believe the only difference between the #11 and #18 is in the bootloader, resp. the firmware.

Here's the reverse side.
Isoprop is offline Find More Posts by Isoprop