Thread: Discussion MJX-F45 Single Rotor FP
View Single Post
Old Jan 01, 2013, 08:15 AM
OldOz is offline
Find More Posts by OldOz
John
Australia, QLD, Brisbane
Joined Aug 2012
542 Posts
Whizgig -
Sorry, I got sidetracked!
The frame-
http://www.hobbyking.com/hobbyking/s...arehouse_.html
the motor -
http://www.hobbyking.com/hobbyking/s...dProduct=11884
The pinion -
http://www.hobbyking.com/hobbyking/s...dProduct=15259. Pretty crummy, but will do the job. If you grind a flat 1/3 the way through the shaft, anyway.
The ESC -
http://www.hobbyking.com/hobbyking/s...idProduct=4312
The landing gear -
Either the standard HK 450 (comes with the kit, very flimsy) covered with Clark pipe lagging tube OR Align HK 500 (Zeejays or Wattsuprc)
Finally, the antirotation bracket is off a particular Align 450 (has a wide flat base, good for epoxy gluing to frame) - I'll identify it later.
Good luck with your build! - And cheers for 2013
John.

PS - the Antirotation -
http://www.wattsuprc.com.au/goods.php?id=952
(they also make a cheaper plastic version that has worked fine so far, but this looks better.. Just dremel a slot (or drill a hole) for the shaft and bearing, and glue it to the frame and bearing support. Hasn't shifted yet!).
I've left the shaft adaptor till last: could probably spare one, if you get stuck (or follow Arrowshooter's suggestion): but what you need is a 5 to 6 mm shaft adaptor, about 4cm long.
OldOz is offline Find More Posts by OldOz
Last edited by OldOz; Jan 01, 2013 at 08:37 AM.
Reply With Quote