View Single Post
Old Dec 31, 2012, 10:23 PM
Jeebs77 is offline
Find More Posts by Jeebs77
Registered User
Jeebs77's Avatar
Joined May 2010
71 Posts
receiver placement

Quote:
Originally Posted by rhampton View Post
Wow that's a great Mod..thanks for sharing...ok well it looks like i'm about done...My only problem is i have had Signal lockout before. I have the AR500 and this is not a typical foam. This seems like a Hard Plastic so i dont know how well my AR500 is going to penetrate signal thru this material...Where do you guys mount your RX...near the battery area? i want to cut a hole in the fuse and have the long wire from the AR500 stick out for better signal....
please advise..
I used an ar6200 with the satellite receiver. the receiver is in front of the servos and the satellite is behind the servos on the bottom of the fuse. I think your idea of a small hole through the plastic for the long ant. would be good. you shouldn't have any problem with the plastic fuse though. I think that only carbon fuselages give the 2.4 receivers problems.
Jeebs77 is offline Find More Posts by Jeebs77
Reply With Quote