Thread: Discussion PLA discharge rate question
View Single Post
Old Dec 30, 2012, 10:34 PM
Stumblebee is offline
Find More Posts by Stumblebee
Registered User
Stumblebee's Avatar
Port Coquitlam, BC CANADA
Joined Jun 2009
2,086 Posts
Quote:
Originally Posted by ksrimoungchanh View Post
Thanks Stumblebee,

I picked up 2 12V deep cell battery 55Ahr each.. I series them together to get 24V.. I was able to get to drain at 8amp.. Great..

On the supply tab of the application, I am not able to change the Battery Low to something more then 12.50.. is that normal? wouldn't that be very low for both batteries series'd?

Also, should I bumped my "Regen. Charge Voltage IN to Pb= to something higher? I am using 22.2 V lipo.

Thank in advance..

KS
On this one I am going to have to defer to someone more knowledgeable in the use of batteries to power the PL8. The bulk of my experience has been using a pair of 12 volt 47 amp server power supplies in series. Regen does not work with them.
Stumblebee is offline Find More Posts by Stumblebee
Reply With Quote