Thread: Discussion PLA discharge rate question
View Single Post
Old Dec 30, 2012, 10:20 PM
ksrimoungchanh is offline
Find More Posts by ksrimoungchanh
Lost in the wind
United States, KS, Overland Park
Joined Jun 2012
206 Posts
Thanks Stumblebee,

I picked up 2 12V deep cell battery 55Ahr each.. I series them together to get 24V.. I was able to get to drain at 8amp.. Great..

On the supply tab of the application, I am not able to change the Battery Low to something more then 12.50.. is that normal? wouldn't that be very low for both batteries series'd?

Also, should I bumped my "Regen. Charge Voltage IN to Pb= to something higher? I am using 22.2 V lipo.

Thank in advance..

KS
ksrimoungchanh is offline Find More Posts by ksrimoungchanh
Reply With Quote