View Single Post
Old Dec 30, 2012, 03:40 PM
dougmontgomery is offline
Find More Posts by dougmontgomery
dougmontgomery's Avatar
Glendale,Az.
Joined Oct 2004
3,563 Posts
place your fg skin in the mold with your templates, moving the fg to the edge of the mold. Then let the epoxy or polyester get tacky so the skin does not move then wet your carbon out on the bench oversized slightly to your templates, then fold your wax paper over your fabric and hard roll it really well at 45 degrees. Then light spray some 3m 77 on your poster board template and stick to the wax paper and cut your carbon out to size after it has been rolled.

Then place in mold, brushing it in the corners nicely.

Then mix up some milled fibers/cabosil/cotton flock 50/50 so it is sticky and place on both halves of the edge of the fabric all the way around so it is standing above the mold, should not sag.

Then close your mold and clamp.

May help- that is how I would do it.

Nice work BTW.

doug
dougmontgomery is offline Find More Posts by dougmontgomery
Reply With Quote